Why might I need this?

If the Spotter firmware update process is interrupted, the Spotter could be left in a state where no LEDs light when powered on in RUN mode. These steps can help recover from that state.

Tools needed

• two paperclips
• hex wrench
• USB-C cable
  • pay attention to cable type:
    • avoid “charge-only” cables which do not carry data
    • avoid high-spec Thunderbolt-capable cables if possible
• Mac or Windows computer

Preparation

1. Carefully lift the Spotter electronics box (ebox), and disconnect cables, as described in Removing and Replacing Spotter Electronics Box (E-Box)
2. Open the battery compartment as described in (Spotter 3 / Non-Bristlemouth) Smart Mooring Bridge Firmware Upgrade Guide
3. Leave the battery connected to Spotter
4. Orient the ebox so the solar connectors are on top, and barometer port & other ports are on bottom
5. Look for the three small holes near the battery strap. You will use two of these with the aforementioned paperclips.

Main process

1. Leave power switch ON